Contact Us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right. 

461 Broome St
New York, NY, 10013
United States

2126252557

Earthquaker Devices Acapulco Gold

A-H

Earthquaker Devices Acapulco Gold

Acapulco-Gold-ff.jpg
Acapulco-Gold-ff.jpg

Earthquaker Devices Acapulco Gold

125.00

Hey there, treasure hunters! The Acapulco Gold is a dirt-simple distortion Device based on the power section of a cranked vintage Sunn Model T, bringing the openness, clarity, and crunch that only a dimed tube amp can provide, at a fraction of the size, and without expensive maintenance costs!

Since tone is in the hands, we decided to keep the controls of the Acapulco Gold as simple as possible. The footswitch turns the pedal on and off, and the giant knob controls the output volume. That's it. The rest is at your fingertips. Want less gain? Turn down your guitar's volume knob. Need a darker rhythm tone? Roll back your guitar's tone control. Easy, right?

With your guitar’s volume all the way up, the Acapulco Gold roars like a wide-open Model T on the verge of explosion. At just-barely-backed-off, the Gold becomes a raunchy overdrive. At minimum guitar volume settings, the Acapulco Gold delivers a hazy, Nashville-sounding spank to your tone.

How about this? If your guitar has separate volume and tone controls for each pickup and a three-way selector switch, this little one-knob banger becomes a three-channel tone monster at the flick of your wrist!

The Acapulco Gold is all-analog, true bypass, and built one-at-a-time by a wandering expedition of prospectors and speculators in dusty Akron, Ohio, USA – the hamburger capital of the world.

The Acapulco Gold uses silent, relay-based soft-touch switching. Audio will not pass without power.

Add To Cart

Controls

Big Knob: The big knob sets the output level, sometimes known as Volume. 

PLEASE BE CAREFUL! The Acapulco Gold is extremely loud!

Measures

4.625″ x 2.5″ x 2.25″ with knob

Power

Our pedals take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages!

Current draw is 30 mA.