Contact Us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right. 

461 Broome St
New York, NY, 10013
United States

2126252557

Earthquaker Devices Erupter

EFFECTS (A-H)

Earthquaker Devices Erupter

EQD+ERUPTER.jpg
EQD+ERUPTER.jpg

Earthquaker Devices Erupter

149.00

Can we ask you a serious question? When’s the last time you turned up your favorite fuzz pedal to anything but eleven? If there’s one true thing about rock n’ roll, it’s that it sounds best cranked all the way up. But where do we go from here? We go one louder. Enter the Erupter.

The Erupter is the result of over two years’ worth of tone-chasing, tweaking, and experimentation in search of the ultimate classic fuzz tone with a big low end, a biting top end without being too harsh, and just enough output to politely send a tube amp over the top to deliver a well-rounded and defined fuzz tone with just enough pummeling intensity, so you can rock n’ roll all night and still get to bed at a reasonable hour.

It’s the perfect fuzz... just sayin’.

Add To Cart


Measures: 4.75" x 2.50" x 2.25" with knobs
Current Draw: 9mA
Input Impedance: 500K Ohm
Output Impedance: <1K Ohm
Switching
This device is true bypass and uses electronic relay-based switching. Audio will not pass without power.

Power
This device can be powered by a 9v battery or a standard 9-volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!