Contact Us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right. 

461 Broome St
New York, NY, 10013
United States

2126252557

Earthquaker Devices Organizer

A-H

Earthquaker Devices Organizer

organizer.jpg
organizer.jpg

Earthquaker Devices Organizer

185.00

Organizer Polyphonic Organ Emulator

The Organizer is a polyphonic organ emulator designed to mimic the
organ tones of yesteryear crossed with the highly unique
“Guitorgan”. The organizer has a warm and very analog  feel
with a hint of Leslie warble that is unlike other modern 
octave shifters. It tracks all over the neck on both guitar
and  bass and will transpose single notes as well as chords.
The  Organizer uses a mix of analog and DSP circuitry with true
bypass switching and an all analog direct (dry) signal path.

Add To Cart

Notes:
The Organizer has an output gain stage with no master control. When
it's idle, even with all knobs at zero, the will be about as much
"white noise" as an average overdrive pedal with it's gain at zero
and the level set to unity. A minimal amount while idle is normal
but it will not be noticeable during play. The sound will be more
apparent in front of a gained up amp or other dirt/gain/boost
pedals.

The controls:

Up: Level control for the octave up.

Down: Level control for the octave down.

Choir: This control takes a mix of the octave up and octave down
setting and regenerates it. The end result is an additional 2
octaves up, 2 octaves down and direct signal with a slight delay
that adds a “church organ” like feel. This control only works if the
octave up and octave down are in use.

Direct: Level control for the analog dry signal.

Tone: Low pass filter for the wet signal, counter clockwise rolls
off the high end.

Lag: Delay control for the wet signal. Full counter clockwise is
minimal delay, delay time increases as it rotates clockwise.

Power
A standard 9 volt DC power supply with a negative center 2.1mm
barrel, current draw is 70ma. No battery option.

Measures
4 5/8" x 2 1/2" x 2.25" with knobs